There is no product that matches the search criteria.
Your cart is empty.
Product 6/10
This 12V LED tape is supplied as a 5m roll and uses 60 SMD 3528 LEDs per metre. Choose the light colour shown in the product options: 2900K warm white or 4200K natural white. The 8mm strip has a white backing with self-adhesive tape and an IP20 rating for dry locations.
Use a compatible 12V LED driver; do not connect the tape directly to mains electricity. At the listed 4.8W/m, a full 5m roll represents a nominal 24W load, or about 2A at 12V. Select a driver rated above the full connected load and follow the driver's specified headroom and installation requirements. Use only a dimmable driver or LED tape dimmer that is compatible with 12V strip and the total load.
Browse our 12V LED drivers and dimmable LED drivers, or see the remote-controlled LED tape dimmer for a compatible control option. Check the individual product ratings and wiring instructions before purchase.
Measure the run before installation and cut only at the marked cut points. Suitable connectors for cut sections are available separately; check the connector type and polarity for this tape. Apply the adhesive backing to a clean, dry surface prepared according to the tape instructions.
IP20 is intended for dry indoor locations. This tape is not specified as water-resistant, so do not install it where it can be exposed to water or condensation. For a damp or outdoor location, choose a product with an appropriate ingress rating for the complete installation.