There is no product that matches the search criteria.
Your cart is empty.
Product 6/10
This 30W constant-voltage LED driver provides a 12V DC output for compatible 12V LED tape and other constant-voltage loads. It is often searched for as a 12V 30W LED transformer. It is not a constant-current driver or a lighting dimmer.
Check voltage and total load: Confirm that the connected lights require 12V constant voltage and that their combined load does not exceed the driver’s 30W rating. A 24V product or constant-current supply is not interchangeable. Check the product instructions if the installation also needs dimming or other control.
Check enclosure and dimensions: The listing specifies an aluminium case with an IP67 rating and dimensions of 202 × 35 × 23mm. The IP rating depends on correct installation and sealed cable entries; check the manufacturer’s instructions and the conditions at the installation site rather than assuming suitability for every wet location.
Mains input and installation: The listed input is 220–230V AC. This is a mains-powered supply; have the wiring and placement checked by a qualified electrician. Confirm the cable route, ventilation and load before commissioning.
Perfect for the job, the cable tails were a perfect length for my application. I over spec'd the rating as I am only running 18 watts on the circuit but it runs cool and no light flicker at all. Good value for money in my opinion.
Came very quickly, easy to fit and did the job perfectly. Will use SLB again for other lighting requirements.
There is so much confusing info out there on the subject of drivers for LED lights I was glad that I was able to buy this one with confidence. It works a treat and is smaller than the old transformer and makes no noise.