There is no product that matches the search criteria.
Your cart is empty.
Product 12/17
This extruded aluminium corner profile is designed to hold LED strip up to 10mm wide. It has 19mm fixing sides and a 29mm visible front, with a frosted diffuser supplied for the selected length. Choose the 1m or 2m option shown on the product page; the listing specifies a minimum order of three lengths for the 2m option.
Measure the mounting corner and confirm that the LED tape is no wider than 10mm. The tape is placed in the channel using its self-adhesive backing. Check that the selected run length, cable route and end-cap openings suit the installation. The diffuser changes how the LEDs appear; the finished light will depend on the strip type and how it is positioned within the channel.
The product listing states that the channel and diffuser can be cut to length with a hacksaw. Measure carefully and follow safe cutting practices; purchase any extra clips or end caps needed for the finished run. An aluminium profile can help manage heat from LED tape when the strip is installed correctly, but choose the tape and power supply for the required output and follow their instructions.
This profile does not make an LED strip waterproof. Select tape with an ingress rating appropriate to the room or installation conditions, and do not assume the channel provides moisture protection. For damp or outdoor locations, check the protection rating of the complete assembled system before installation.
Compare the 1m and 2m corner channel options, then check the minimum order and included fixings before adding the required length to your project.
Really good product used this profile on my bathroom ceiling, had recessed between the wall tiles and the new plaster board wedged siliconed in between. Also good inside the niches.