There is no product that matches the search criteria.
Your cart is empty.
Product 4/11
This 5m roll of 24V RGB LED strip tape is rated at 7.2W per metre. It has 30 SMD 5050 LEDs per metre, a 10mm width, white adhesive backing and an IP20 rating. At the listed rate, the full roll represents a 36W tape load before power-supply and controller losses.
Use a suitable 24V DC supply and an RGB controller rated for the tape’s voltage and total load. Size both from their product ratings and the length being installed; allow for the power supply and controller requirements. For a standalone setup, see the RGB tape controller. A DMX installation needs a compatible DMX decoder as well as a suitable 24V supply. Our 24V LED drivers can be compared against your system requirements.
For the same electrical power, a 24V system draws less current than a 12V system, which can help manage voltage drop. The permitted run length still depends on the tape, cable, feed points and manufacturer’s installation guidance. Do not assume that 24V alone guarantees a longer run.
IP20 tape is intended for dry indoor locations and is not protected against water. Do not use it outdoors or where it may be exposed to moisture unless the complete installation has an appropriate rated enclosure. The adhesive backing needs a clean, dry mounting surface. Follow the fitting and tape instructions when positioning the strip.
The tape is supplied as a 5m roll and may be cut only at the marked cut points. Switch off the supply before cutting or wiring. Each cut length needs a correctly connected 24V supply and RGB control; use suitable connectors or wiring for the installation. Check polarity and channel connections before powering the tape, and test the lighting before fixing the strip permanently.